铝合金导电管焊接缺陷及解决措施

李博强; 贾昕宇; 谭茜茜; 雷强

doi:10.7512/j.issn.1001-2303.2020.01.22

焊接工艺 | 浏览量 : 0 下载量: 65 CSCD: 0

PDF
导出
分享
收藏
专辑

铝合金导电管焊接缺陷及解决措施
Analysis and solutions on welding defects of aluminum alloy conductive tube
2020年50卷第1期页码：114-116
DOI： 10.7512/j.issn.1001-2303.2020.01.22

扫描看全文

李博强, 贾昕宇, 谭茜茜, 等. 铝合金导电管焊接缺陷及解决措施[J]. 电焊机, 2020,50(1):114-116.

LI Boqiang, JIA Xinyu, TAN Xixi, et al. Analysis and solutions on welding defects of aluminum alloy conductive tube[J]. 2020,50(1):114-116.
李博强, 贾昕宇, 谭茜茜, 等. 铝合金导电管焊接缺陷及解决措施[J]. 电焊机, 2020,50(1):114-116. DOI： 10.7512/j.issn.1001-2303.2020.01.22.

LI Boqiang, JIA Xinyu, TAN Xixi, et al. Analysis and solutions on welding defects of aluminum alloy conductive tube[J]. 2020,50(1):114-116. DOI： 10.7512/j.issn.1001-2303.2020.01.22.

摘要

对铝合金导电管焊接接头进行X射线检测组织分析,发现接头中出现气孔、夹渣、未熔合及未焊透等缺陷。详细分析接头缺陷的产生原因,通过优化坡口结构、焊接方法、调整焊枪位置及焊接参数,消除了导电管焊接接头出现的缺陷。

Abstract

Through the X-ray analysis of the welded joint of aluminum alloy conducting pipe,it is found that there are defects such as porosity,slag inclusion,incomplete fusion and incomplete penetration in the joint. The causes of defect were analyzed in detail,and defects in conductive tube welding joint defects were eliminated by optimizing groove structure and welding method,adjusting welding torch position and welding parameters.