重点关注 | 浏览量 : 54 下载量: 231 CSCD: 1
  • 导出

  • 分享

  • 收藏

  • 专辑

    • AP1000核岛主设备不锈钢堆焊层首层铁素体含量研究

    • Study of ferrite number of the first layer for AP1000 nuclear island equipment stainless steel cladding

    • 王莉

      1

      杜玉华

      1
    • 2019年49卷第12期 页码:29-31   

    扫 描 看 全 文

  • 引用

    阅读全文PDF

  • 王莉, 杜玉华. AP1000核岛主设备不锈钢堆焊层首层铁素体含量研究[J]. 电焊机, 2019,49(12):29-31. DOI:
    WANG Li, DU Yuhua. Study of ferrite number of the first layer for AP1000 nuclear island equipment stainless steel cladding[J]. 2019,49(12):29-31. DOI:
    论文导航

    摘要

    AP1000核岛主设备中堆芯补水箱内表面均需堆焊不锈钢材料,堆焊层结构为EQ309L(首层)+EQ308L(耐蚀层)。按照设计要求,首层EQ309L熔敷金属需满足铁素体含量为3~20 FN,但在实际制造中发现无法满足该要求。通过研究不同施焊参数下的铁素体含量,发现常用埋弧焊参数无法满足铁素体要求。结合制造过程分析,制定了相应的处理措施,并结合工程实际对后续设计优化提出建议。

    EN

    Abstract

    The inner surface of core make-up tank(CMT)in nuclear island shall be overlaid with stainless steel for which the first layer is EQ309 L and the corrosion resistant layer is EQ308 L. According to the design requirements,the first layer of EQ309 L shall meet the ferrite content of 3~20 FN. However,it is found that no SAW parameters can meet the content. The treatment of the first layer ferrite which can not meet the design requirements and subsequent design suggestions according to engineering practice are given.

    EN

    关键词

    AP1000; 核岛主设备; 不锈钢堆焊; 首层; 铁素体含量

    EN

    Keywords

    AP1000; main equipment in nuclear island; stainless steel cladding; first layer; ferrite content

    EN

    文章被引用时,请邮件提醒。
    提交

    相关作者

    暂无数据

    相关机构

    北京金威焊材有限公司
    国家钢结构工程技术研究中心焊接技术研究院
    中冶建筑研究总院有限公司
    国核工程有限公司
    环境保护部核与辐射安全中心
    0