不锈钢焊接接头低倍金相检验的制样方法

代绪成; 侯大震; 刘宏; 赵顺利

焊接工艺 | 浏览量 : 0 下载量: 143 CSCD: 0

PDF
导出
分享
收藏
专辑

不锈钢焊接接头低倍金相检验的制样方法
Specimen Preparation method of macrographic examination for stainless steel welding joints
2019年49卷第3期页码：89-91
DOI：

扫描看全文

代绪成, 侯大震, 刘宏, 等. 不锈钢焊接接头低倍金相检验的制样方法[J]. 电焊机, 2019,49(3):89-91.

DAI Xucheng, HOU Dazhen, LIU Hong, et al. Specimen Preparation method of macrographic examination for stainless steel welding joints[J]. 2019,49(3):89-91.
代绪成, 侯大震, 刘宏, 等. 不锈钢焊接接头低倍金相检验的制样方法[J]. 电焊机, 2019,49(3):89-91. DOI：

DAI Xucheng, HOU Dazhen, LIU Hong, et al. Specimen Preparation method of macrographic examination for stainless steel welding joints[J]. 2019,49(3):89-91. DOI：

摘要

对电解腐蚀在不锈钢焊接接头低倍金相检验中的运用进行研究,通过试验选定腐蚀溶液、腐蚀时间和输出电流等参数。结果表明:采用10 mL HNO,3,+90 mL H,2,O腐蚀溶液,输出电流2 A,在室温下腐蚀6 min,制备出清晰的不锈钢焊接接头低倍金相试样,可清晰显示焊接接头各个区域。

Abstract

The application of electrolytic corrosion in the macrographic examination for stainless steel welding joints is studied,the corrosion solution,corrosion time and output current are selected by experiments. The results show that after being corroded in the corrosion solution consisting of 10 ml nitric acid and 90 ml water for 6 minutes at room temperature with output current of 2 A,a clear macroscopic morphology specimen of stainless steel welding joint is prepared,and the each regions of welding joints can be clearly displayed.

关键词

不锈钢焊接接头低倍金相检验电解腐蚀

Keywords

stainless steelwelding jointsmacrographic examinationelectrolytic corrosion

references

文章被引用时，请邮件提醒。

提交

不锈钢焊缝铁素体含量预测方法综述

钽与不锈钢异种材料焊接的研究进展