熔积电流对镁合金CMT熔丝增材成形特征的影响

倪加明; 刘思余; 陈梦凡; 王锋华; 李宝辉

doi:10.7512/j.issn.1001-2303.2021.08.17

增材制造 | 浏览量 : 0 下载量: 523 CSCD: 0

PDF
导出
分享
收藏
专辑

熔积电流对镁合金CMT熔丝增材成形特征的影响
Effect of depositio n current on forming characteristics of CMT wire arc additive manufactured magnesium alloy
2021年51卷第8期页码：128-133
纸质出版：2021
DOI： 10.7512/j.issn.1001-2303.2021.08.17
稿件说明：

移动端阅览

倪加明, 刘思余, 陈梦凡, 等. 熔积电流对镁合金CMT熔丝增材成形特征的影响[J]. 电焊机, 2021,51(8):128-133. DOI： 10.7512/j.issn.1001-2303.2021.08.17.

NI Jiaming, LIU Siyu, Chen Mengfan, et al. Effect of depositio n current on forming characteristics of CMT wire arc additive manufactured magnesium alloy[J]. Eletric Welding Machine2021, 51(8): 128-133. DOI： 10.7512/j.issn.1001-2303.2021.08.17.

摘要

针对AZ80镁合金CMT熔丝增材制造工艺

开展不同熔积电流对镁合金直壁试样成形特性的影响规律研究。结果表明

CMT熔丝增材熔积速度为10 mm/s时

熔积电流在85～125 A范围内可获得成形良好的单道镁合金直壁试样

稳定成形直壁高度比起弧、熄弧位置略高

高度偏差控制在2.6 mm以内;随着熔积电流从85 A增至125 A

熔积层层间层高从2.39 mm减小到2.16 mm

而熔积层层宽则从8.61 mm增至14.23 mm;熔积电流过大或过小均会影响直壁试样的表面粗糙度

熔积电流为105 A时表面粗糙度最小

粗糙度为0.16 mm。

Abstract

For the CMT wire arc additive manufacturing of AZ80 magnesium alloy

the influence of different deposition currents on the forming characteristics of magnesium alloy samples was studied. The results show that the single-pass magnesium alloy samples with good shaping can be obtained by CMT wire arc additive manufacturing with a deposition speed of 10 mm/s and the deposition current of 85～125 A. The height of the middle stable region is slightly higher than that of the arc starting and arc ending points. And the height deviation is controlled within 2.6 mm. With the deposition current increasing from 85 A to 125 A

the height of the deposited layer decreases from 2.39 mm to 2.16 mm

while the width of the deposited layer increases from 8.61 mm to 14.23 mm. Too large or too small deposition current will affect the surface roughness of the samples. The minimum surface roughness is 0.16 mm when the deposition current is 105 A.