钛换热管与管板焊接接头电化学腐蚀性能研究

崔巍; 高磊; 王东丽; 崔艳军

doi:10.7512/j.issn.1001-2303.2020.08.25

焊接工艺 | 浏览量 : 0 下载量: 521 CSCD: 0

PDF
导出
分享
收藏
专辑

钛换热管与管板焊接接头电化学腐蚀性能研究
Study on electrochemical corrosion test of welding joint between TA2 heat exchange tube and TA2 tube sheet
2020年50卷第8期页码：124-128
纸质出版：2020
DOI： 10.7512/j.issn.1001-2303.2020.08.25
稿件说明：

移动端阅览

崔巍, 高磊, 王东丽, 等. 钛换热管与管板焊接接头电化学腐蚀性能研究[J]. 电焊机, 2020,50(8):124-128. DOI： 10.7512/j.issn.1001-2303.2020.08.25.

CUI Wei, GAO Lei, WANG Dongli, et al. Study on electrochemical corrosion test of welding joint between TA2 heat exchange tube and TA2 tube sheet[J]. Eletric Welding Machine2020, 50(8): 124-128. DOI： 10.7512/j.issn.1001-2303.2020.08.25.

摘要

利用动电位极化曲线和电化学阻抗谱研究两种接头形式、三组焊接电流共六组焊接工艺参数下的钛换热管与钛管板焊接接头在3.5%的NaCl溶液中的电化学腐蚀性能。结果表明:平接形式各组焊接工艺参数下的接头试样耐蚀性均优于角接

其中Ⅳ号(平接形式、焊接电流140 A)试样的耐蚀性能最优。选择合适的焊接工艺参数有利于提高焊接接头的耐蚀性能。

Abstract

Potentiodynamic polarization curves and electrochemical impedance spectroscope were used to study corrision behavior by the six groups welding process parameters of two joint forms and three groups of welding current in 3.5% Na Cl solution. The results show that the erosion resistance of the butt welding under the each welding process parameters is better than the fillet welding

the numbered Ⅳ parameter is optimal.Choosing good welding process parameters can improve the corrosion resistance of welding joint.