低表面能修饰工艺对涂层接触角的影响研究

刘楠; 张相宁; 杨桂英; 席乃园; 刘艳

doi:10.7512/j.issn.1001-2303.2020.08.18

焊接工艺 | 浏览量 : 0 下载量: 677 CSCD: 0

PDF
导出
分享
收藏
专辑

低表面能修饰工艺对涂层接触角的影响研究
Study on the influence of low surface energy modification on the contact angle of coating
2020年50卷第8期页码：86-90
纸质出版：2020
DOI： 10.7512/j.issn.1001-2303.2020.08.18
稿件说明：

移动端阅览

刘楠, 张相宁, 杨桂英, 等. 低表面能修饰工艺对涂层接触角的影响研究[J]. 电焊机, 2020,50(8):86-90. DOI： 10.7512/j.issn.1001-2303.2020.08.18.

LIU Nan, ZHANG Xiangning, YANG Guiying, et al. Study on the influence of low surface energy modification on the contact angle of coating[J]. Eletric Welding Machine2020, 50(8): 86-90. DOI： 10.7512/j.issn.1001-2303.2020.08.18.

摘要

针对冬季高速列车转向架区域结冰现象

制备防覆冰涂层来减缓该现象。采用超音速火焰喷涂WC-Co粉末制备微纳结构涂层

并在其表面修饰不同低表面能物质

研究低表面能修饰工艺对涂层表面静态接触角的影响。结果表明:采用不同浓度和工艺参数处理的疏水气相纳米二氧化硅均可提高接触角

最佳低表面能修饰工艺为:SiO

丙酮溶液浓度20 mg/mL

喷涂距离250～300 mm

喷射角度75°～80°

喷枪移速60 mm/s

喷涂道次为5次

压缩空气压力为0.65 MPa。采用该工艺可获得接触角为154.3°±3.0°

滚动角为4.1°±0.1°的涂层。

Abstract

For the icing phenomenon in the bogie area of high-speed train in winter

the anti-icing coating is prepared to slow down the phenomenon. In this paper

the micro-nano structure coating is prepared by supersonic flame spraying WC-Co powder

and different low surface energy materials are modified on its surface to study the influence of low surface energy modification on the static contact angle of coating. The results show that adopting hydrophobic fumed nano silica treated with different concentrations and procedure parameters

the contact angle can be increased. The optimum low surface energy modification procedure is as following:the concentration of Si O2 acetone solution is 20 mg/m L

spraying distance is250 ～300 mm

spraying angle is 75° ～80°

spray gun moving speed is 60 mm/s

spraying passes are 5 times

and compressed air pressure is 0.65 MPa. And the contact angle of 154.3° ±3.0° and rolling angle of 4.1° ±0.1° can be obtained by this procedure.