不同热处理对TC4/Ti60电子束焊接头微观组织及力学性能的影响

王世清; 邢博; 赵启喆; 焦迎香; 强伟

doi:10.7512/j.issn.1001-2303.2020.05.03

焊接工艺 | 浏览量 : 0 下载量: 527 CSCD: 3

PDF
导出
分享
收藏
专辑

不同热处理对TC4/Ti60电子束焊接头微观组织及力学性能的影响
Effect of heat treatment on microstructure and tensile properties of electron beam welded TC4/Ti60 joint
2020年50卷第5期页码：16-20
纸质出版：2020
DOI： 10.7512/j.issn.1001-2303.2020.05.03
稿件说明：

移动端阅览

王世清, 邢博, 赵启喆, 等. 不同热处理对TC4/Ti60电子束焊接头微观组织及力学性能的影响[J]. 电焊机, 2020,50(5):16-20. DOI： 10.7512/j.issn.1001-2303.2020.05.03.

WANG Shiqing, XING Bo, ZHAO Qizhe, et al. Effect of heat treatment on microstructure and tensile properties of electron beam welded TC4/Ti60 joint[J]. Eletric Welding Machine2020, 50(5): 16-20. DOI： 10.7512/j.issn.1001-2303.2020.05.03.

摘要

采用不同热处理工艺对10 mm厚的钛合金TC4/Ti60电子束焊接接头进行了研究

对比分析了TC4/Ti60接头在分别经历退火700℃×2 h(AC)及固溶时效980℃×1 h(FC)+700℃×2 h(AC)后

在显微组织、显微硬度及拉伸性能等方面的特征。结果表明:TC4/Ti60接头经过退火后

组织和性能与焊态相当

但当TC4/Ti60接头经过固溶时效后

TC4/Ti60接头的组织更均匀

硬度及强度比退火时略低

并且塑性增加

综合性能良好。

Abstract

The electron beam welding（EBW） joint of 10 mm thick titanium alloy TC4/Ti60 was studied by different heat treatment processes. The microstructure

microhardness and tensile properties of TC4/Ti60 joint after annealing and solution aging were compared and analyzed. The results show that after annealing

the microstructure and properties of TC4/Ti60 joint are similar to those of as welded joint;after solution aging

the microstructure of TC4/Ti60 joint is more uniform

the hardness and strength are slightly lower than that of annealed joint

but the plasticity is increased and the comprehensive properties are good.