基于DSP的无桥PFC变换器研究

朱才青; 曹彪; 钟磊; 江伟

doi:10.7512/j.issn.1001-2303.2020.01.10

焊接设备 | 浏览量 : 0 下载量: 1011 CSCD: 0

PDF
导出
分享
收藏
专辑

基于DSP的无桥PFC变换器研究
Research on bridgeless PFC converter based on DSP
2020年50卷第1期页码：63-66
纸质出版：2020
DOI： 10.7512/j.issn.1001-2303.2020.01.10
稿件说明：

移动端阅览

朱才青, 曹彪, 钟磊, 等. 基于DSP的无桥PFC变换器研究[J]. 电焊机, 2020,50(1):63-66. DOI： 10.7512/j.issn.1001-2303.2020.01.10.

ZHU Caiqing, CAO Biao, ZHONG Lei, et al. Research on bridgeless PFC converter based on DSP[J]. Eletric Welding Machine2020, 50(1): 63-66. DOI： 10.7512/j.issn.1001-2303.2020.01.10.

摘要

针对传统开关电源桥式整流滤波部分给电网带来的谐波污染

高效率无桥功率因数变换器成为国内外学术界以及工业界的研究热点。立足于双二极管式无桥PFC(2nd DBPFC)变换器

完成变换器系统方案设计与器件选型

详细分析其工作模态

并结合平均电流控制策略完成2nd DBPFC变换器控制程序的编写。基于含有DSP内核的PIC32MK1024MCF064芯片

研制了一台1 kW的2nd DBPFC变换器。试验结果表明

变换器在220 V输入满载条件下

功率因数达到98.7%。

Abstract

Aiming at the harmonic pollution caused by the traditional switching power supply bridge rectifier filter

the high efficiency bridgeless power factor converter has become a research focus in academia and industry at home and abroad.Based on the dual-diode bridgeless PFC（2nd DBPFC）converter

the converter system design and components selection are completed

its working mode is analyzed in detail

and the 2nd DBPFC converter control system is completed combining the average current control strategy. Finally

based on the PIC32MK1024 MCF064 chip with DSP core

a 1 kW 2nd DBPFC converter was developed. The test results show that the converter has a power factor of 98.7% at 220 V input full load.