CP-Ti激光焊接接头组织与性能研究

黄忠宝; 王鹏飞; 尚立宝; 陈永亮; 刘登邦

重点关注 | 浏览量 : 0 下载量: 40 CSCD: 0

导出
分享
收藏
专辑

CP-Ti激光焊接接头组织与性能研究
Study on microstructure and properties of laser welding joint of CP-Ti
2018年48卷第12期页码：13-16
纸质出版：2018
DOI：
稿件说明：

移动端阅览

黄忠宝, 王鹏飞, 尚立宝, 等. CP-Ti激光焊接接头组织与性能研究[J]. 电焊机, 2018,48(12):13-16. DOI：

HUANG Zhongbao, WANG Pengfei, SHANG Libao, et al. Study on microstructure and properties of laser welding joint of CP-Ti[J]. Eletric Welding Machine2018, 48(12): 13-16. DOI：

摘要

采用光学显微镜等观察和测试CP-Ti激光焊接头组织和硬度

对比接头在酸性、中性和碱性环境中的耐腐蚀性能。结果表明:接头各区域组织均为α相

其中焊缝中的α晶呈针状、锯齿状和板条状3种形貌

在热影响区则为锯齿状。硬度测试表明

焊缝为接头硬度值最高区域

显微硬度达到210 HV

热影响区次之

约为165 HV。接头在酸性环境中的耐蚀性最差

表现为其电流密度、腐蚀速率均高于碱性和中性环境中的。

Abstract

The microstructure and hardness of laser welding joint of CP-Ti are investigated with some technologies

and the corrosion resistance of joint in acid

neutral and alkaline solutions are also studied. The results show that the microstructure of joint consists of αphase

and the α grains in welds have three kinds of appearance

which are acicular

serrated and lath shaped and α grains in heat affected zone（HAZ）are serrated. The hardness test shows that the weld is the area with the maximum joint microhardness of 210 HV

and the microhardness of HAZ is about 165 HV

which is lower than that of weld. The corrosion resistance of joints in acid solution is the worst

the current density and corrosion rate in acid solution are higher than those in neutral and alkaline solutions.