马氏体耐磨堆焊药芯焊丝熔敷金属组织与性能

牛犇; 任香会; 易江龙; 刘勇

焊接工艺 | 浏览量 : 0 下载量: 193 CSCD: 3

导出
分享
收藏
专辑

马氏体耐磨堆焊药芯焊丝熔敷金属组织与性能
Microstructure and mechanical properties of martensitic wear-resistant flux cored wire by surfacing welding
2018年48卷第6期页码：83-86
纸质出版：2018
DOI：
稿件说明：

移动端阅览

牛犇, 任香会, 易江龙, 等. 马氏体耐磨堆焊药芯焊丝熔敷金属组织与性能[J]. 电焊机, 2018,48(6):83-86. DOI：

Microstructure and mechanical properties of martensitic wear-resistant flux cored wire by surfacing welding[J]. Eletric Welding Machine2018, 48(6): 83-86. DOI：

摘要

采用自制马氏体耐磨药芯焊丝制备马氏体堆焊层

通过焊接实验研究其焊接成形

并分析其组织和性能。结果表明:堆焊组织为马氏体+残余奥氏体组织

其平均硬度为50 HRC

堆焊层底部硬度低于表面硬度;堆焊层平均磨损失重为1.7 mg

堆焊层耐磨性优于42Cr Mo材料

堆焊层平均抗弯强度为1 182 MPa

与42Cr Mo钢材的抗弯强度较为接近。

Abstract

Surfacing weld was carried out by using martensitic wear-resistant flux cored wire.The welding form

microstructure and mechanical properties were analyzed.The results show that the weld characterized by martensite and retained austenite and the average hardness is 50 HRC.The average of surfacing weld wear loss is 1.7 mg

which is better than that of 42 Cr Mo steel.The average bending strength of layer surfacing weld is 1 182 MPa

which is similar to 42 Cr Mo steel.