核岛主设备蒸汽发生器主承压焊缝焊接工艺研究

刘鸣宇; 杨志鹏; 吴义党

核电焊接 | 浏览量 : 0 下载量: 903 CSCD: 1

PDF
导出
分享
收藏
专辑

核岛主设备蒸汽发生器主承压焊缝焊接工艺研究
Research on welding procedure for main pressure-retaining welds of nuclear island main equipment steam generator
2019年49卷第9期页码：64-69
纸质出版：2019
DOI：
稿件说明：

移动端阅览

刘鸣宇, 杨志鹏, 吴义党. 核岛主设备蒸汽发生器主承压焊缝焊接工艺研究[J]. 电焊机, 2019,49(9):64-69. DOI：

LIU Mingyu, YANG Zhipeng, WU Yidang. Research on welding procedure for main pressure-retaining welds of nuclear island main equipment steam generator[J]. Eletric Welding Machine2019, 49(9): 64-69. DOI：

摘要

主承压焊缝的焊接是核岛汽发生器制造过程中关键工艺。对核岛蒸汽发生器低合金钢高强度钢材料18MND5与SA508Gr3Cl2分别采用焊条电弧焊与埋弧焊进行焊接试验

对比分析两种材料在不同焊接工艺下的化学成分与力学性能

建议补充对比分析结论。结果表明:18MND5与SA508Gr3Cl2的焊条电弧焊和埋弧焊试板的拉伸性能良好

试验性能稳定

均能满足相关标准设计要求。

Abstract

The welding for main pressure-retaining welds is a key procedure in the manufacturing of nuclear island steam generator.The welding experiments of SAW and SMAW for 18MND5 and SA508Gr3Cl2 are respectively performed. The chemical composition and mechanical properties of these two materials under different welding procedures are compared and analyzed. The results show that the test pieces of 18MND5 and SA508Gr3Cl2 with SAW and SMAW have good tensile property and stable test performance

and both can meet the related standard design requirements.