激光焊焊前预热和焊后热处理对焊缝质量的影响

汤亨强; 杨平; 柳美玲

焊接工艺 | 浏览量 : 0 下载量: 1004 CSCD: 3

PDF
导出
分享
收藏
专辑

激光焊焊前预热和焊后热处理对焊缝质量的影响
Effect of preheating and post-welding heat treatment on weld quality
2019年49卷第3期页码：99-102
纸质出版：2019
DOI：
稿件说明：

移动端阅览

汤亨强, 杨平, 柳美玲. 激光焊焊前预热和焊后热处理对焊缝质量的影响[J]. 电焊机, 2019,49(3):99-102. DOI：

TANG Hengqiang, YANG Ping, LIU Meiling. Effect of preheating and post-welding heat treatment on weld quality[J]. Eletric Welding Machine2019, 49(3): 99-102. DOI：

摘要

为了研究激光焊接热处理工艺对焊缝组织和性能的影响

制定了焊前预热和焊后热处理的试验方案。采用金相显微镜和扫描电镜对焊缝组织观察分析

并用HV0.1显微硬度计检测焊缝区域硬度。结果表明

经过焊前预热和焊后热处理的金相组织铁素体明显增多

而珠光体较少

硬度较低

其中焊后热处理对组织和性能改善的最为显著。

Abstract

In order to study the effect of laser welding heat treatment process on the microstructure and properties of weld

pre-welding and post-welding heat treatment were established. Metallographic microscope and scanning electron microscope were used to observe and analyze the microstructure of the weld

and used HV0.1 microhardness tester to measure the hardness of the weld area. The results showed that by means of pre-welding and post-welding heat treatment

the ferrite in the metallographic structure increased obviously

while the pearlite was less and the hardness was lower

especially the post-welding heat treatment improved the microstructure and properties most significantly.